Completing The Restore On A File Serving Node - HP StorageWorks x9720 Administrator's Manual

IMPORTANT:
console is enabled and an active agile management console is configured.
If you have configured a user network, enter a VIF IP address and netmask.
If you configured a passive management console, enter the following command to verify the
status of the console:
ibrix_fm -i
Next, complete the restore on the file serving node.

Completing the restore on a file serving node

1. Ensure that you have root access to the node. The restore process sets the root password to
hpinvent, the factory default.
2. Run the exds_stdiag command from the node that was just restored. You should be able
to see the shared storage, just as you can from the other server blades in the chassis.
3. Disable the microcode_ctl service:
chkconfig microcode_ctl off
Configure a passive agile management console only if the agile management
Configuring a file serving node 129