Completing The Restore On A File Serving Node - HP StorageWorks X9320 Administrator's Manual

If you configured a passive management console, enter the following command to verify the
status of the console:
ibrix_fm -i
Next, complete the restore on the file serving node.

Completing the restore on a file serving node

Complete the following steps:
1. Ensure that you have root access to the node. The restore process sets the root password to
hpinvent, the factory default.
2. The QuickRestore DVD enables the iptables firewall. Either make the firewall configuration
match that of your other server blades to allow traffic on appropriate ports, or disable the
service entirely by running the chkconfig iptables off and service iptables
stop commands.
To allow traffic on appropriate ports, open the following ports:
80
443
1234
9000
9005
9008
9009
3. If you disabled NIC monitoring before using the QuickRestore DVD, re-enable the monitor:
ibrix_nic -m -h MONITORHOST -A DESTHOST/IFNAME
For example:
ibrix_nic -m -h titan16 -A titan15/eth2
4. If this file serving node was previously configured as an NDMP host, run the following command
to start NDMP services each time the node is rebooted:
chkconfig ibrix_ndmp on
To start NDMP services now, run the following command:
/etc/init.d/ibrix_ndmp start
90 Recovering a file serving node