Before Requesting Service; Specifications - Panasonic mc-ul592 Operating Instructions Manual

BEFORE REQUESTING SERVICE

WARNING
Disconnect the electrical supply before servicing or cleaning the vacuum cleaner.
Failure to do so could result in electrical shock or personal injury from vacuum cleaner suddenly starting.
Review this chart to find do-it-yourself solutions for minor performance problems.
Any service needed, other than those described in these Operating Instructions, should be performed by an authorised
service representative.
PROBLEM
Vacuum Cleaner won't
run.
Poor job of dirt
pick-up.
Beater bar does not
turn.

SPECIFICATIONS

Specifications
Power source
Max. input
Nominal input
Dimensions (L x W x H)
Net weight
Dusting brush
Extension wand
Crevice
Floor nozzle
• Design and specifications may be changed without prior notice.
• Weight and dimensions shown are approximate.
REMINDER FOR CUSTOMER
The model and serial number of this product may be found on the name plate located at the rear of your vacuum cleaner.
You should note that the model and serial number in the spaces provided and retain this book as a permanent record of your purchase.
Model Number : _________________________________________________________
Serial Number : _________________________________________________________
Date Purchased : _________________________________________________________
Where Purchased : _________________________________________________________
Electrical Shock or Personal Injury Hazard
POSSIBLE CAUSE
1. Unplugged at socket outlet.
2. Mains plug fuse blown.
3. Thermal protector tripped.
1. Full or clogged dust bin.
2. Worn beater bar.
3. Clogged nozzle.
4. Clogged hose.
5. Hole in hose.
6. Hose not inserted fully.
7. Dirty filters.
1. Switch knob at "FLOOR" position.
2. Broken belt.
3. Overload Protection Reset Button on the Nozzle
tripped.
POSSIBLE SOLUTION
1. Plug in firmly, turn on vacuum cleaner.
2. Check fuse and replace it if blown.
3. Unplug vacuum cleaner, allow to cool and thermal
protector will reset itself.
1. Empty dust bin.
2. Take to your nearest Panasonic Service Center.
3. Check for clogs.
4. Check for clogs.
5. Take to your nearest Panasonic Service Center.
6. Check hose connection.
7. Clean or change the Dust Compartment Filter Kit
(page 18).
8. Change the Exhaust Filter (page 18).
1. Move switch knob to the "CARPET" position.
2. Replace belt.
3. Push the Overload Protection Reset Button to reset.
MC-UL592
230 - 240 V ~ 50 Hz
1400 W
1200 - 1300 W
391 mm x 372 mm x 1100 mm
8.6 kg
✔
1 pc
✔
-
MC-UL594
1500 W
8.8 kg
2 pcs
✔
17