Cleaning Beater Bar; Cleaning Exterior And Tools - Panasonic mc-ul592 Operating Instructions Manual

End Cap
Slot

CLEANING BEATER BAR

a) Beater Bar for Nozzle
Beater Bar
b) Beater Bar for Mini Turbine Nozzle
Beater Bar

CLEANING EXTERIOR AND TOOLS

• Unplug the mains lead from electrical outlet.
• Clean exterior using a clean, soft cloth that has been dipped in water and wrung dry.
• Dry wipe after above cleaning.
• DO NOT drip water on the vacuum cleaner.
• DO NOT clean tools in dishwasher or clothes washer.
• Wash tools in warm water, rinse and air dry.
• DO NOT use tools if they are wet.
• Loop new belt around motor shaft and beater bar belt groove.
• Reinstall the beater bar by inserting the end cap of the beater bar to the
slot for both side.
Nozzle
• After reinstalling the beater bar, turn it by hand to make sure that belt is
not twisted or pinched and that all rotating parts turn freely.
• Reinstall lower plate. See "Removing and Installing Lower Plate".
• Clean beater bar for Nozzle and Mini Turbine Nozzle after every five uses.
• Turn vacuum cleaner over, exposing the beater bar for Nozzle.
• Cut off any carpet pile and lint entangled around beater bar for Nozzle
and Mini Turbine Nozzle with a pair of scissors.
15