Maintaining The Hepa Filter Unit; To Clean The Pre-Filter - Panasonic mc-ul592 Operating Instructions Manual

MAINTAINING THE HEPA FILTER UNIT

Lid
Pull to release
HEPA Filter
Unit

TO CLEAN THE PRE-FILTER

Pre-Filter Tab
12
• Check HEPA filter unit frequently and clean when dirty.
• Remove HEPA filter unit from dust bin by pulling both buckle as shown.
Pull to release
• Clean HEPA filter unit by gently tapping over a rubbish container.
Tap on Lid several sides to ensure best cleaning.
DO NOT clean the HEPA filter unit by brush or clean it with water.
Buckle
• Reinstall the HEPA filter unit as per reverse procedure.
Dust Bin
• Remove HEPA filter unit from dust bin. Refer to maintaining the HEPA
filter unit (as above).
• Press the latch to open the dust bin plate.
• Grasp the pre-filter and turn it clockwise and pull the pre-filter out as shown.
Clean by gently tapping over a rubbish container.
Pre-Filter
• Install the pre-filter to the dust bin, aligning the pre-filter tabs to the dust
bin slots. Each Pre Filter Tabs is different shape and adjust it to match
Dust Bin Slot, then turn counter-clockwise to the lock position until you
hear a "click" sound as shown.
Dust Bin Slot
• After the dust bin is empty, firmly close the dust bin plate.
Make sure you hear a "click" sound to indicate that the dust bin plate is
fully latched.
• Reassemble the HEPA filter unit. Place dust bin unit back into vacuum
cleaner by inserting the bottom first and tilting back.
Refer to dust bin cleaning (pg.10).