Troubleshooting; Technical Specification - Buffalo CD969 Instruction Manual

Troubleshooting

Fault
The unit is not working
Appliance does not remove all the air from the
bag
Bags are not sealing correctly
Error message E1 in Digital Display
Error message E2 in Digital Display
NOTE: Sealing bar replacement is not covered under warranty

Technical Specification

Model Voltage Power
CD969 230v 50hz
The Unit is not switched on
Plug and lead are damaged
Fuse in the plug has blown
Power supply
Internal wiring fault
Bag not correctly positioned
Open end of bag is dirty
Bag may be punctured
Incorrect bags used
Moisture in bag under the sealing bar
Incorrect bags used
End of bag not placed above sealing bar
Sealing Bar requires replacement
Lid in poor contact with chamber
Lid Gasket distorted or broken
Internal system leak
Safety switch / electronic fault
Current
350W 1.5A
Telephone Helpline: 0845 146 2887 (United kingdom)
Probable Cause
Vacuum Pressure
(approx.)
-950mbar
-5-
Action
Check the unit is plugged in correctly and
switched on
Call BUFFALO agent or qualified technician
Replace the plug fuse
Check Power Supply
Call BUFFALO agent or qualified technician
Open lid and reposition bag
Clean bag
Replace bag
Call Vacuum Pack machine supplier
Ensure inside of the bag is dry and free from
moisture where it is to be sealed
Call Vacuum Pack machine supplier
Move end of bag over sealing bar
Call BUFFALO agent or qualified technician
Clean lid gasket and chamber
Replace the lid gasket
Call BUFFALO agent or qualified technician
Call BUFFALO agent or qualified technician
Dimensions
h x w x d mm
270 x 415 x 410
Weight
(kg)
12.6