Cleaning, Care And Maintenance; Troubleshooting - Buffalo DK208 Instruction Manual

6. At anytime during vacuum cycle pressing the Seal button will override timer and complete the
vacuuming and sealing cycle.
7. After the vacuum process the machine automatically goes to sealing cycle.
8. When sealing, seal time setting will be shown on the Digital Display and count down from default
setting to 0. Note: Seal time setting is adjustable from 3-9 (1.8-5.4 seconds). Default
setting is 8 (4.8 seconds).
9. Take out the bag and check the vacuum and seal. (Note: A good seal will look clear upon inspection.
If the seal is spotty, incomplete, wrinkled, white or milky, remove sealed portion and run vacuum and
seal process again.)
10. Press "ON/OFF" button to stop the machine at any time.
Please store the vacuumed items properly. All perishable foods must be refrigerated or
frozen to prevent spoilage.
Cleaning, Care & Maintenance
Always allow to cool before cleaning.
WARNING: Do not allow any water to spill into the appliance when cleaning.
• Use warm, soapy water and a damp cloth to clean the appliance.
• Dry thoroughly after cleaning.
• A BUFFALO dealer or qualified technician should carry out repairs if required.

Troubleshooting

Fault
The appliance is The unit is not switched on
not working
Plug or lead is damaged
Fuse in the plug has blown
Power supply
Appliance does Bag not correctly positioned
not remove all
Open end of bag is dirty
the air from the
Bag may be punctured
bag
Incorrect bags used
Bags are not Moisture in bag under the sealing
sealing correctly bar
Incorrect bags used
End of bag not placed above sealing
bar
Heat sealing foam bar missing or
incorrectly aligned
Sealing Bar requires replacement
Sealing bar/lid seal is dirty
DK208_ML_A5_v1_20210630.indb 5 DK208_ML_A5_v1_20210630.indb 5
Probable Cause Solution
Check the unit is plugged in correctly and
switched on
Call BUFFALO agent or qualified Technician
Replace the plug fuse
Check power supply
Open lid and reposition bag
Clean bag
Replace bag
Call Vacuum Pack machine supplier
Ensure inside of the bag is dry and free from
moisture where it is to be sealed
Call Vacuum Pack machine supplier
Move end of bag over sealing bar
Replace or re-position
Call BUFFALO agent or qualified technician
Clean sealing bar/lid seal
UK
5
2021/6/30 13:09 2021/6/30 13:09