Sharp XEA201 Parts And Their Functions page 2

How do I prepare my XEA201 for set-up?
Take the XEA201 out of its box, remove the packing materials. Place the XEA201 on a flat stable surface,
close to a power outlet. Also insure it will not be exposed to direct sunlight, and is away from water (taps,
sinks, etc).
How do I clear the XEA201 to ready it for programming?
It is very important that you "initialise" the XEA201 correctly once you have removed it from the box, and
are ready to start programming. If you do not "initialise" the XEA201, it might not work correctly.
1. Insert the Mode key into the mode switch and turn it to the REG position.
2. Plug the AC adapter connector into the AC adapter jack, then plug the AC adapter into the wall
outlet.
This must be done without the batteries installed. If you have installed batteries; be sure to remove
them before you start this procedure.
After a few seconds, the register should beep three times, and the display should look as indicated
below.
The register is initialised.
If the beeps are not heard as described, the initialisation has not been successful. If this is the case:
disconnect the register from the AC outlet, wait at least one minute, and then try again.
If there were any data from a previous programming attempt, they would have been cleared
XEA201 Frequently Asked Questions Page 2 of 17