Select Options; Extra Rinse - Maytag HAV2460AWW Use & Care Manual

STEP 4
Select Cycle
To select a cycle, push the control dial IN and turn it to
the right (clockwise) until the pointer is at the soil level
needed for the wash load.
Wrinkle Free Fabrics/Delicates Cycle
Wrinkle Free Fabrics/Delicates cycles share the same
portion of the control dial. For wrinkle free fabrics,
select the cycle and turn the Wash/Spin Speed dial to
Wrinkle Free Fabrics. For delicate loads select Delicates.
Regular Cycle
This cycle provides up to 16 minutes of agitation.
Select the Regular Wash/Spin Speed.
Soak Only (select models)
Provides 4 minutes of agitation, then soak. Avoid
extended soaking – soak for 30 minutes or less.
The control dial must be manually advanced to a spin
setting to spin and drain the water.
See Laundering Tips for proper washing procedures,
stain removal, and special laundering situations.
STEP 5
(if desired)

Select Options

Extra Rinse

When the knob is in the "Extra Rinse" position, an
additional rinse at the end of the Regular and Wrinkle
Free Fabrics/Delicates cycles is provided to more
completely remove laundry additives, suds, perfumes, etc.
Signal
The end of cycle signal will sound once the cycle is
completed. The end of cycle signal can be canceled by
setting the knob to off.
If both Extra Rinse and an end of cycle signal are
desired, turn the Options knob to Extra Rinse/Signal.
STEP 6
Pull Control Dial Out to Start
You may stop the washer at any time by simply
pushing the control dial IN. Therefore it is possible to
obtain a non-agitated soak or to shorten, skip or
repeat any part of a cycle. The control dial must be
pushed IN (off position) when you change the setting.
Note
• Do not attempt to turn the control dial
counterclockwise. Damage to the timer will result.
10