Table of Contents
Advertisement
Then the TIME
MONITOR
will convert to the
temperatures are selected. A warm finn rinse cannot be
approximate total minutes remaining in the cycle,
provided on a permanent press cycle or when using a hot
This feature lets you know when to return to the
or cold wash temperature on any cycle.
washer to remove >'our load.
Start the Washer
Select
Options
After a wash cycle program has been selected, the wash-
Options are selected by pressing the pad once or
er ,a411fill to the selected water level with the selected
canceled by pressing the pad again,
wash water temperature.
After lqlling, it will agitate for
Slow
Spin
the selected nmnber of minutes.
Pressing this pad provides a slow spin speed on any
The washer
will pause
briefly
throughout
each
cycle selected,
eyele. These pauses are normal.
Off
This washer is designed so that it will not agitate or spin
Pressing this pad cancels all selections and stops the
when the lid is open. It will, however, fill with the lid
washer,
open so water is available for pretreating
stains or dilut-
ing fabric softener.
Presoak
Should the lid be opened during a eyele, the washer will
This option provides a convenient and eeonomical
stop; when the lid is dosed the washer will resmne its
method of treating heavily soiled and stained loads,
cycle at the point it was interrupted.
It will soak with brief periods of agitation for a
selected
time and automatically
advance into a
NOTE: Ifthewasher
stops during the spin it maybe
wash cycle without draining,
due to an unevenly distributed load. If this_happens,
To use this option:
push in the controlknob, open the lid, redistribute the
1. Select a wash cycle,
load, close the lid and pull out the control knob,
2. Choose wash temperature,
water level and wash
Program
Monitor
Features
time.
Unbalanced
Signal
3. Press PRESOAK pad. (Wash water temperature
and presoak water
temperature
will be the
If the washer stops due to an unevenly distributed
same,)
clothes
load, "UNBALANCED"
will light in the
Monitor. One minute later an audible signal will sound.
4. If needed, decrease presoak time from 30 rain-
This signal will continue to sonnd every minute. To con-
utes or increase time up to 60 minutes by press-
tinue the cycle, redistribute
the load and close the lid.
ing one of the time adjust pads. Generally, soak
The washer will automatically resume the cycle at the
periods up to 30 minutes are sufficient for most
point it was interrupted.
loads.
Sequence
Indicators
5. Use up to 50% more than the usual amomat of
Words light in the Monitor as the washer advances
detergent or use a presoak product such as Biz °
through each portion of the %vole -- "SOAK, WASH,
in addition to the regular amount of detergent.
RINSE, X-RINSE and SPIN."
*Brand n a_r_aretheo'ademarks o f &e_pective nuznufacturer_.
Extra
Rinse
Soil
Level
indicators
The soil level indicators will light in the Monitor to help
An additional deep rinse is automatically added to
match the wash time to the soil level of the load. For
the selected cycle by using the EXTRA RINSE
example, if the load is lightly soiled, agitation time can
option. To select, press the EXTRA RINSE pad.
be decreased
and fewer indieator lights will light indi-
The water temperature
will be the same as the ini-
eating appropriate agitation time for the load.
tial rinse.
Warm
Rinse
Pressing this pad will provide a warm final rinse when
energy saver hot, warm or energy saver warm water
PAGE 7
Advertisement
Table of Contents
