Operation; General Controls - NEC MultiSync LT 80 User Manual

3 O P E R A T I O N
This section describes how to select a computer or video source and how to adjust the
picture and sound.
General Controls Before you turn on your MultiSync LT80 Projector, ensure that the
computer or video source is turned on and that your lens cap is removed.
1. Turn On The Projector The main power switch is on the back panel of the
MultiSync LT80 Projector. By turning this switch on, the projector will go into its
standby mode and the power light will glow amber. Only after you press the "On"
button on the remote control or projector cabinet will the power light turn to green
and the projector become ready to use.
NOTE: To turn the projector on and off with just the back panel switch, use the menu
and enable the "auto start" feature. (See page 59. )
2. Select The Computer Or Video Source Press the "Video" (VCR, DVD player,
document camera, or laser disc player), "S-video", or "RGB" (computer) button on
the remote control to display the image. Or press the "Menu" button on the cabinet
and use the icons to select your video source: "Video", "S-Video", or "RGB".
3. Adjust The Image Size Adjust the size of the screen with the zoom ring lever on the
projector.
4. Focus Adjust the focus with the focus ring on the projector.
5. Turning Off The Projector First press the "off" button on the remote control or the
projector cabinet. The power light will glow amber. Then turn off the main power
switch on the back panel. The power light will go out.
IMPORTANT:
• The projector should be unplugged if it will not to be used for an extended period.
• To turn off the image briefly (five minutes or less), use the "Picture Mute" button
instead of turning the projector off and on.
• The projector will display a black, or blue image if no input signal is present.
• Do not turn the projector off and then immediately back on. The projector needs to
cool for a minute before it can be restarted.

OPERATION

49
50