Step 5 - Line-Specific Configuration - Linksys PAP2 Configuration Manual

VoiceDirector Device Configuration Guide
3. If you set DHCP to no, enter the Static IP, NetMask, and Gateway
4. Click the Save Settings button at the bottom of the page to save the
STEP 5 – LINE-SPECIFIC CONFIGURATION
1. Click the Line1 or Line2 tab at the top of the page, and in the NAT
2. In the Proxy and Registration section (see the screen on the following
System Tab
information.
If you set DHCP to yes, continue to step 5.
settings.
Settings section, change the following setting:
Field
NAT Keep Alive Enable
page), change the following settings:
Field
Proxy
NOTE: If using a DNS, do not
include "http://" in the Proxy
name. For example, if the DNS
name is 000.00.000.00, enter
000.00.000.00 as the Proxy.
Value
no
Page 3
Linksys PAP2
Value
Enter the
VoiceDirector
IP address or
DNS name.