INTRODUCTION
Safety protect by Passcode and Security functions
Passcode and Security features prevent the projector from being used by
unauthorized individuals.
Passcode prevents unauthorized individuals from changing projector set-
tings or adjustments Security offers complete protection by using your PC
card as a protect key so that the projector will not project a signal without
insertion of the registered PC card and unauthorized use can be discour-
aged.
• The built-in Viewer allows you to start your presentation even when a
PC is not available at the site.
• A high-bright 220 watt DC lamp.
• The Standby mode reduces standby power consumption significantly.
• The supplied wireless remote control that operates the projector from
the front side or rear.
• The image can be projected between 30 and 500 inches (measured
diagonally).
• The "Capture" enables you to capture the current projected image.
• An image can be projected from in front or behind a screen, and the
projector can even be installed on the ceiling.
• NEC's exclusive Advanced AccuBlend intelligent pixel blending tech-
nology - an extremely accurate image compression technology - of-
fers a crisp image with UXGA (1600 1200) resolution*
• Supports most IBM VGA, SVGA, XGA , SXGA/UXGA(with Advanced
AccuBlend)*
other RGB signals within a horizontal frequency range of 24 to 100
kHz and a vertical frequency range of 50 to 120 Hz. This includes
NTSC, PAL, PAL-N, PAL-M, PAL60, SECAM and NTSC4.43 stan-
dard video signals.
*
Introduction to the Projector
3
, Macintosh, component signal (YCbCr/ YPbPr) or any
3
A UXGA (1600 1200) and SXGA image (1280 1024) are displayed
with NEC's Advanced AccuBlend on LT260/LT240/LT220.
An XGA image (1024
AccuBlend on LT220.
768) is displayed with NEC's Advanced
E-3
3
.