Operation Using An Http Browser - NEC LT240 User Manual

APPENDIX

Operation Using an HTTP Browser

Overview
The use of HTTP server functions will allow control of the projector from a
web browser without the installation of special software. Please be sure to
use "Microsoft Internet Explorer 4.x" or a higher version for the web browser.
(This device uses "JavaScript" and "Cookies" and the browser should be
set to accept these functions. The setting method will vary depending on
the version of browser. Please refer to the help files and the other informa-
tion provided in your software.)
NOTE:
* The use of HTTP server functions is not available during Standby mode.
* The display's or button's response can be slowed down or operation may not be
accepted depending the settings of your network. Should this happen, consult
your network administrator.
* The projector may not respond if its buttons are repeatedly pressed in rapid
intervals. Should this happen, wait a moment and repeat. If you still can't get
any response, pull out and then re-insert the LAN card.
Access is gained to the HTTP server functions by specifying
http:// <the projector's IP address> /index.html
in the entry column of the URL.
Preparation Before Use
Make network connections and set up the projector and confirm that it is
complete before engaging in browser operations. (See "Setting LAN Mode"
on page E-102.)
Operation with a browser that uses a proxy server may not be possible
depending on the type of proxy server and the setting method. Although
the type of proxy server will be a factor, it is possible that items that have
actually been set will not be displayed depending on the effectiveness of
the cache, and the contents set from the browser may not be reflected in
operation. It is recommended that a proxy server not be used unless it is
unavoidable.
E-135