How To Use Remote Controller - Toshiba MMK-AP0073H Owner's Manual

SMMS High-Wall Type
8

HOW TO USE REMOTE CONTROLLER

Cooling/heating/fan only
operation
Start
PRESET
1
START/STOP button (
Press this button to start the air conditioner.
2
Mode select button (MODE)
Select Cool
3
Temperature button (
Set the desired temperature.
When the air conditioner is in FAN ONLY operation,
the temperature display is not indicated.
4
Fan speed button (FAN)
Select one of
MED , MED
HIGH
• The OPERATION lamp (green) on the
display panel of the indoor unit goes on. And
operation starts after approximately 3 minutes.
(If you select FAN ONLY mode, the unit will start
immediately.)
• The : Fan only mode does not control
temperature.
• Fan speed
HIGH
Therefore, perform only steps
select this mode.
Stop
START/STOP button (
Press this button again to stop the air conditioner.
NOTE
When the indoor unit is operated together with a
cooling only outdoor model outdoor unit,
appears on the remote controller but the heating
operation is disabled.
11-EN
3
4
FAN
TEMP
1
MODE
2
)
, Heat , or Fan only
)
TEMP
+
LOW , LOW
+
,
.
is the same as
.
1 2
, and
)
Dry operation
Start
1
START/STOP button (
Press this button to start the air conditioner.
2
Mode select button (MODE)
Select DRY
3
Temperature button ( )
.
Set the desired temperature.
• The fan speed display indicates
• The
display panel of the indoor unit lights, and
operation starts after approximately 3 minutes.
,
Stop
START/STOP button (
Press this button again to stop the air conditioner.
4
to
– 11 –
PRESET FAN
TEMP
MODE
)
.
TEMP
OPERATION lamp (green) on the
)
Owner's Manual
3
1
2