Remote 1 Connector - NEC GT5000 User Manual

m REMOTE 1 Connector
5 4 3 2 1
10 9 8 7 6
15 14 13 12 11
This connector is used for a third party external control device.
Pin No.
14
5
10
3
11pin
4,8,12,11
OPEN
OPEN
OPEN
OPEN
OPEN
OPEN
OPEN
SHORT
SHORT
SHORT
SHORT
SHORT
SHORT
* When combinations other than specified in the above table are selected or when no optional board is inserted in the Slot 1
and 2, the input will be switched to RGB 1 by default.
* The term "SHORT" means to connect with pin 15
* When in the external control mode, the POWER, Source/Input, PICTURE MUTE and SOUND MUTE buttons on the remote
control will not function.
* When the External control mode is set to ON, the following settings are not effective: Source Select, Auto Start, Power
Management, Power off Confirmation, Idle mode, Default Source Select, Timer and Test Pattern.
NOTE: When turning off the power to the projector using the external control, do not disconnect the plug from the power outlet. These
procedures are to protect your projector and the connected equipment.
SHORT/OPEN
SHORT
OPEN
SHORT
OPEN
SHORT
OPEN
SHORT
OPEN
12pin 8pin
OPEN OPEN
OPEN OPEN
OPEN SHORT
SHORT OPEN
SHORT OPEN
SHORT SHORT
SHORT SHORT
OPEN OPEN
OPEN OPEN
OPEN SHORT
SHORT OPEN
SHORT OPEN
SHORT SHORT
External control mode ON
External control mode OFF
POWER ON
POWER OFF
PICTURE MUTE ON
PICTURE MUTE OFF
MUTE SOUND ON
MUTE SOUND OFF
4pin
RGB 1
OPEN
SHORT VIDEO
OPEN S-VIDEO
Slot 1-1
OPEN
RGB 2
SHORT
OPEN Slot 1-2
SHORT RGB1 (S-VIDEO)
DVI (DIGITAL)
OPEN
SHORT VIEWER
SHORT RGB1 (VIDEO)
Slot 2-1
OPEN
SHORT Slot 2-2
OPEN LAN
10-9
10. Appendix
FUNCTION