Fitting The Wall Bracket To A Mast Or Support; Fitting The Wall Bracket To Metal Supports; Do Not Warp Or Deform The Wall Bracket - Fronius Symo 3 Installation Instructions Manual

Fitting the wall
bracket to a mast
or support
Fitting the wall The wall bracket must be fastened at a minimum of four points.
bracket to metal
1
1
supports
Do not warp or
deform the wall
bracket
12
NOTE! When fitting the wall bracket to the wall, ensure that the wall bracket does
not become warped or deformed.
When installing the inverter on a mast or
support, Fronius recommends the "Pole
Clamp" kit from Rittal GmbH (order no. SZ
2584.000).
This kit enables the inverter to be installed
on round or rectangular masts with the fol-
lowing diameters: from 40 to 190 mm
(round mast), from 50 to 150 mm (rectan-
gular mast)