Install The Mounting Bracket And Hang Up The Inverter; Selecting The Fixing Material; Properties Of The Mounting Bracket; Do Not Deform The Mounting Bracket - Fronius Primo GEN24 3.0 Operating Instructions Manual

Install the mounting bracket and hang up the in-
verter
Selecting the fix- Use the corresponding fixing materials depending on the subsurface and observe
ing material the screw dimension recommendations for the mounting bracket.
The installer is responsible for selecting the right type of fixing.
Properties of the
mounting brack-
et
Do not deform
NOTE!
the mounting
bracket When fitting the mounting bracket to the wall or column, ensure that the
mounting bracket does not become deformed.
A deformed mounting bracket may make it difficult to clip/swivel the inverter in-
to position.
Fitting the IMPORTANT!
mounting brack- When installing the mounting bracket, make sure that it is installed with the ar-
et to a wall row pointing upwards.
58
The mounting bracket (illustration) can
also be used as a guide.
The pre-drilled holes on the mounting
bracket are intended for screws with a
thread diameter of 6-8 mm (0.24-0.32
inches). The distance from the left to
the right pre-drilled hole is 406 mm
(16 inches).
Unevenness on the mounting surface
(such as coarse-textured plaster) is
largely compensated by the mounting
bracket.