When Used With One Switcher (Iss-6020/Iss-6020G - NEC GT2150 User Manual

When Used with One Switcher (ISS-6020/ISS-6020G)

Up to 10 input signals can be accepted when the projector is connected to one Switcher. Using the projector with
the Switcher allows easy adjustment and signal selection.
OUTPUT
RGB 1
VIDEO 1
VIDEO 2
IN IN
REMOTE
PC CONTROL
2
OUT OUT
REMOTE 1 SC. TRIGGER
• Select [Projector Options]
• For more information on the Switcher, refer to the user's manual accompanying the ISS-6020/ISS-6020G Switcher.
• All cables mentioned above are sold separately.
• The RGB2 terminal will not work with the Switcher Control function.
To use the projector with the Switcher ISS-6020 in the Switcher Control mode,
* When connecting with the VIDEO INPUT MODULE (6020-VID), set the VIDEO MODE select switch (S3001) to "8". The VIDEO MODE select
switch is located on the VIDEO INPUT MODULE (6020-VID).
NOTE: While in the Switcher Control mode, a video standard is selected at the projector.
* If you set the VIDEO MODE select switch (S3001) to "8" with the QUAD DECODER installed in the Switcher ISS-6020, the image will not be
displayed correctly.
In that case, first remove the QUAD DECODER from the Switcher ISS-6020.
For more details, contact your dealer.
RGB 2
ANALOG
R/Cr G/Y B/Cb
H/HV V
L/MONO R L/MONO R
L/MONO R L/MONO R
S VIDEO AUDIO OUT
Optional control cable 15p-15p
(CTL-6010)
[Switcher Control] [SW1 Level]. See page E-51 for the information in detail.
BNC 5 coaxial cable
To RGBHV output
To audio output
To REMOTE1
E – 28
ISS-6020
VCR
VCR
Personal computer
To slot
Personal computer
To audio input
Audio system