Kenwood DDX6016BTR Instruction Manual page 69

REFERENCES REFERENCES
No operations are available when playing back a
track containing artwork.
• Operate the unit after the artwork has loaded.
Videos cannot be played.
• Connect with USB Audio and Video cable
KCA-iP202 (optional accessory) to iPod/iPhone
30-pin connector model. Other cables cannot be
used.
• Select [USB+AV-IN] for <iPod Setup>.
(Page 22)
No sound of videos comes out.
• Connect with USB Audio and Video cable
KCA-iP202 (optional accessory) to iPod/iPhone
30-pin connector model. Other cables cannot be
used.
• Select [USB+AV-IN] for <iPod Setup>.
(Page 22)
❏ Radio
AME automatic presetting does not work.
• Store stations manually. (Page 26 )
Static noise while listening to the radio.
• Connect the aerial firmly.
❏ Digital Radio (DAB) (only for
DDX4016DAB)
Cannot receive an ensemble.
• Your area is not covered by the ensemble.
The DAB aerial is not properly extended or
positioned.
• Adjust the aerial and try the ensemble scanning
again.
• Connect an active aerial (not supplied).
❏ AV-IN
"AV-IN" cannot be selected on the Home screen.
• Select [USB 1 Wire] for <iPod Setup>.
(Page 22)
No picture appears on the screen.
• Turn on the video component if it is not on.
❏ Bluetooth
Phone sound quality is poor.
• Reduce the distance between the unit and the
Bluetooth mobile phone.
• Move the car to a place where you can get a better
signal reception.
The sound is interrupted or skipped while using a
Bluetooth audio player.
• Reduce the distance between the unit and the
Bluetooth audio player.
• Disconnect the device connected for Bluetooth
phone.
• Turn off, then turn on the unit.
(When the sound is not yet restored) connect the
player again.
The connected audio player cannot be
controlled.
• Check whether the connected audio player
supports AVRCP (Audio/Video Remote Control
Profile).
The Bluetooth device does not detect the unit.
• Search from the Bluetooth device again.
The unit does not pair with the Bluetooth device.
• For devices compatible with Bluetooth 2.1:
Register the device using a PIN code. (Page 38)
• For devices compatible with Bluetooth 2.0:
Enter the same PIN code for both the unit and
target device. If the PIN code of the device is not
indicated in its instructions, try "0000" or "1234."
• Turn off, then turn on the Bluetooth device.
Echo or noise occurs.
• Adjust the microphone unit position.
• Adjust the echo volume or noise reduction
volume. (Page 40)
The unit does not respond when you try to copy
the phone book to the unit.
• You may have tried to copy the same entries (as
stored) to the unit.
ENGLISH 69