Axis P1364 User Manual page 71

AXIS P1364 Network Camera
Troubleshooting
Poor rendering of H.264
images
Color saturation is different
in H.264 and Motion JPEG
Lower frame rate than
expected
Status and Network indicator LEDs are flashing red rapidly
Hardware failure
Product does not start up
Product does not start up
Video and image problems, general
Image unsatisfactory
No audio
Incorrect setup
Poor audio quality
Stuttering
Unsynchronized audio and
video using H.264
Distorted audio
Feedback loops
Ensure that your graphics card is using the latest driver. The latest drivers can usually be
downloaded from the manufacturer's website.
Modify the settings for your graphics adapter. Refer to the adapter's documentation for more
information.
See Performance Considerations on page 77.
Reduce the number of applications running on the client computer.
Limit the number of simultaneous viewers.
Check with the network administrator that there is enough bandwidth available.
Check in the AMC Control Panel (H.264 tag) that video processing is NOT set to Decode only
key frames.
Lower the image resolution.
Set a Capture Mode that prioritizes frame rate. Changing the capture mode to prioritize frame rate
will lower the maximum resolution. See Capture Mode on page 24.
The maximum frames per second is dependent on the utility frequency (60/50 Hz) of the Axis
product. See Technical Specifications on page 73.
Contact your Axis reseller.
If the product does not start up keep the network cable connected and re-insert the power cable
to the midspan.
Check the video stream and camera settings under Setup > Video & Audio > Video Stream and
Setup > Video & Audio > Camera Settings.
Check the sound card in the computer. Ensure that mute is not selected and that the volume
settings are correct.
Check that Enable audio support is selected under Setup > System Options > Security > Audio
Support.
Check that the correct Audio Input source is selected under Setup > Video & Audio > Audio
Settings.
Reduce the number of listeners and viewers. Decrease image resolution and compression.
Synchronize the product's date and time settings with an NTP server. Go to Setup > System
Options > Date & Time.
Check that the correct Audio Input source is selected under Setup > Video & Audio > Audio
Settings.
Feedback loops might appear in full-duplex mode. Try moving the microphone or the speaker, or
use half-duplex mode instead.
71