Start-Up; Charging The Built-In Battery; Switching On; Switching Off - Loewe Audiodesign Speaker 2go 52231 Series Operating Instructions Manual

Speaker 2go
Operating instructions

Start-up

Charging the built-in battery

The battery in the device is already installed ex factory. Before the first use, the battery must be
charged for about 3 hrs. With a fully charged battery the Speaker 2go is operational for about
8 hrs.
Insert the plug (S) into the socket
Then plug the power adaptor (N) into a 110-240V 50/60Hz mains socket.
11
The battery charge level is shown by the LED indicator
LED pulsing red:
LED pulsing white:
LED lights up white:

Switching on

ON/OFF
Set the slide switch
Turn on the Speaker 2go using the key
During battery operation the battery capacity level is shown by the LED.
Battery capacity more than 25%:
Battery capacity 11% to 25%:
Battery capacity 5% to 10%:
Battery capacity is below 5%:

Switching off

Switch the Speaker 2go to the standby mode using the key
The LED indicator
After 10 minutes without audio playback or key operation, the Speaker 2go
automatically switches to standby mode.
ON/OFF
When the speaker is not used for a longer time and before a transport, set the
sliding switch
13 14
12
Device standby, charging battery
Device standby, battery fully charged
Device switched on
11
to the ON position.
2
goes off.
11
to the OFF position.
- 22 -
12
at the rear side of the Speaker 2go.
S
1
. The LED indicator
LED lights up white.
LED lights up red.
LED blinking red.
Speaker 2go switches off (safety buffer).
N
2
.
2
lights up.
1
.