6RMI0-02A
Check
1. Compare the flared work with the figure by.
2. If a flared section is defective, cut it off and
do flaring work again.
Connecting the Piping
Indoor unit
1. Pull the screw cap at the bottom of the indoor unit
2. Remove the chassis cover from the unit by
loosing 2 screws
3. Pull back the tubing holder.
4. Remove pipe port cover and positioning the
tubing
Smooth all round
Inside is shiny without scratches
Inclined
Even length
all round
Indoor unit back side view
Right
Backwards
Inverter Single
Inverter Single
Inverter Single
Inverter Single
= Improper flaring =
Surface
Cracked Uneven
damaged
thickness
Chassis cover
Pipe Port
Left
Tubing holder
Installation
65