Displaying Current Day And Time; Changing The Clock Day And Time; Changing Default Cleaning Times - Polaris 9350 Owner's Manual

Page 14
S e c t io n 5 . P r o gr a m m ing t he
C le a ne r
( 9 4 5 0 S p o r t / P 9 4 5 a nd 9 5 5 0 S p o r t / P 9 5 5 o nly )
You can program up to seven preset cleaning cycles to run
the cleaner on a specific day and time when you are away
from the pool.
N O T E: You cannot change programming or display current
day and time during a cleaning cycle.
5 . 1 D isp la y ing C u r r e nt D a y a nd T im e
• Press
to display current day and time in
24-hour clock format.
C u r r e nt d a y a nd t im e is d isp la y e d f o r 5 se c o nd s.
5 . 2 C ha nging t he C lo c k D a y a nd T im e
1. Press and hold
All days of the week flash twice.
2. Press or
seven (7) days and display desired day.
3. Press to select.
Current hour setting flashes.
4. Press or
24 hours and display desired hour setting.
for three (3) seconds.
buttons to cycle through
buttons to cycle through
N O T E: Control unit is set to display time in 24-hour
clock format. Time setting will cycle through 1-24.
5. Press
to select.
Current minutes setting flashes.
6. Press or
through 1-59 minutes and display desired
minutes setting.
7. Press to select.
8. Press to set time and exit the menu.
9. Press to display current day and time
setting and verify the time you set is correct.
5 . 3 C ha nging D e f a u lt C le a ning T im e s
Use to change cleaning surface setting.
Default cleaning times are:
B o t t o m
B o t t o m
2 hours 30 minutes
W a t e r line ( 9 5 5 0 S p o r t / P 9 5 5 ) :
Variable cleaning time depending on settings
1. Press or
decrease cleaning time in 30-minute increments.
2. Press to select.
buttons to cycle
O nly : 1 hour 30 minutes
a nd S id e s:
buttons to increase or