Synchronizing The Remote Control; Storing The Cleaner - Polaris 9350 Owner's Manual

• To remove the cleaner from the pool using the remote
control, press (see Figure 20).
The cleaner rotates left until you release the Lift
System button.
4 . 8 S y nc hr o niz i ng t he R e m o t e C o nt r o l
Even though the remote control is factory-synchronized
to your cleaner's control unit, it may be necessary to
synchronize again if you need to replace either the
control unit or the remote control.
• To synchronize the remote control to the control unit:
Press and hold for 3 seconds to turn on remote.
Plug the control unit into a power source.
When the display shows the operating time, press
and simultaneously for six (6) seconds.
• The display shows
normal operating time display to indicate the cleaner
is now synched with the remote and ready to begin
operating in remote control mode.
4 . 9 S t o r ing t he C le a ne r
The cleaner must be cleaned regularly using slightly
soapy clean water. Do not use solvents such as
trichlorethylene or its equivalent. Rinse the cleaner
generously using clean water. Do not let your cleaner
dry in direct sunlight near the pool. The cleaner must be
stored on its caddy so that it dries quickly.
1. Place the rear wheels on the caddy side wedges.
2. Place cleaner in vertical position on the caddy
base and clip to hook (Figure 23).
3. Disconnect the cable from the control unit.
Replace the protective cap on the control unit.
4. Starting at the cleaner head. Remove all coils
and tangles from the cable (Figure 22).
followed by the
F igu r e 2 2 . S m o o t h t he P o w e r C a b le
5. Loosely coil the power cable starting at the
cleaner and moving toward the connection point
at control unit. Store the cable by wrapping
it around the hook located on the front of the
caddy (Figure 23).
F igu r e 2 3 . C le a ne r C o r r e c t ly S t o r e d o n C a d d y
Page 13