Plug And Play - NEC MULTISYNC P1150 User Manual

E - 2

Plug and Play

Plug and Play is the new Microsoft® solution with Windows® 95 to
provide automatic peripheral connections without confusing and
time-consuming setup. When used with a Plug and Play compatible
system and video card, the MultiSync P1150 monitor automatically tells
the system its identification and capabilities. The system will then select
its highest resolution and refresh rate to take advantage of your
MultiSync monitor.
BNC/D-SUB Selection
Up-front BNC/D-SUB Selection Button on the monitors allows you to
connect two systems to one MultiSync P1150 monitor. This front panel
button allows you to select a system. Use the MultiCable with the
D-Sub connector to display the video of one system, and use the BNC
inputs to display the video of another system. Using the same P1150
monitor, you can easily select either one of the systems by simply
pushing the BNC/D-SUB Button.
GlobalSync
Eliminates color impurity that may result from Earth's magnetic field.
ErgoDesign
The MultiSync ErgoDesign features enhance human ergonomics
(human and earth conditions). MultiSync monitor's ErgoDesign will
improve the working environment, protect the health of the user and
save money. ErgoDesign parallels the strict European standards of
power management and reduced emissions:
–
automatic display power-down (also known as NUTEK
specification 803299)
–
emission characteristics (stricter than those referred to as
reduced electromagnetic fields as recommended by MPR II
and, for JC-2145UMB, also by TCO)
–
safety (EN 60950)
Introduction