NEC MultiSync L182R4 User Manual page 10

are standard and cannot be changed). Color temperature increases or
decreases, in each preset. R,Y,G,C,B,M,S: Increases or decreases Red, Yellow,
Green, Cyan, Blue, Magenta and Saturation depending upon which is
selected. The change in color will appear on screen and the direction (increase
or decrease) will be shown by the color bars. NATIVE: Original color
presented by the LCD panel that is unadjustable..
Tools 1
SHARPNESS: This function is digitally capable to keep crisp image at any timings.
It is continuously adjustable to get distinct image or soft one as you prefer, and set
independently by different timings.
The number of adjustment steps is different depending on whether EXPANSION
Mode is OFF, FULL or ASPECT (1600 x 1200 is OFF Mode).
EXPANSION MODE: Sets the zoom method.
FULL: The image is expanded to 1600 x 1200, regardless of the resolution.
ASPECT: The image is expanded without changing the aspect ratio.
OFF: The image is not expanded.
CUSTOM (Digital input and Resolution of 1600 x 1200 only): Select one
of seven expansion rates. In this mode the resolution may be low and
there may be blank areas. This mode is for use with special video cards.
RESOLUTION NOTIFIER: This optimal resolution is 1280 x 1024. If ON is
selected, a message will appear on the screen after 30 seconds, notifying
you that the resolution is not at 1280 x 1024.
VIDEO DETECT: Selects the method of video detection when more than one
computer is connected.
FIRST DETECT: The video input has to be switched to "FIRST DETECT"
mode. When current video input signal is not present, then the monitor
searches for a video signal from the other video input port. If the video
signal is present in the other port, then the monitor switches the video
source input port to the new found video source automatically. The
monitor will not look for other video signals while the current video source
is present.
LAST DETECT: The video input has to be switched to the "LAST DETECT"
mode. When the monitor is displaying a signal from the current source
and a new secondary source is supplied to the monitor, then the monitor
will automatically switch to the new video source. When current video
input signal is not present, then the monitor searches for a video signal
from the other video input port. If the video signal is present in the other
port, then the monitor switches the video source input port to the new
found video source automatically.
NONE: The Monitor will not search the other video input port unless the
monitor is turned on.
LCD1860NXManual102802.p65
–continued
8
8 10/28/02, 5:15 PM