Adjusting The Cutting Height - Worx WG784E Original Instructions Manual

STARTING
1) Insert safety key into the housing of the
switch box.
2) Slide the key to the right and hold in
position.
3) pull the lever bar towards the handle and
the mower will start.
4) Release the safety key.
STOPPING
Release the switch lever.
2. INSTALLING mULCh INSERT (14)
(See Fig. h)
1) Turn the mower off, wait until the blade
stops and remove the safety key (6).
2) Raise the safety guard and hold it up.
3) Slide the mulching insert into the discharge
opening until it is firmly in contact with the
deck.
4) Release safety guard and ensure it is
properly closed.
3. REmOVING mULCh INSERT(14)
(See Fig. h)
To remove the mulching insert so that you can
collect the grass, follow the steps listed below:
1) Shut the mower off, wait until the blade
stops and remove the safety key.
2) Raise the safety guard and hold it up.
3) Grasp the middle of the insert, lift and pull
out the mulching insert completely.
4) The safety guard is spring loaded. When
you release it, the guard will return to the
closed position.
4. wORK mODE DIAL (See Fig. I)
Status1: QUIET mode
Select QUIET mode when mowing in everyday
conditions, removing approximately 20mm of
grass at a time.
Status2: TURBO mode
Set the dial to TURBO mode when cutting
dense or overgrown grass.
Cordless lawn mower
5. BATTERy STATUS LED'S (See Fig. J)
NOTE: The Status LED's will indicate the
battery condition when the button on the
battery is pressed.
The LED's constantly senses and displays the
battery condition as follows:
press the button "pOWERTEST" , the light
button is illuminated.
When the three green lights are illuminated,
the battery is in a highly charged condition.
When two lights (
battery is in a moderately charged condition.
When only one green light (
the battery charge is depleted.
Before using your new mower for the first
time, it is recommended that the unit be
charged overnight to ensure that the battery is
fully charged.
ImPORTANT
when only one light is illuminated,
your battery is overly discharged, even
though the mower may still be capable
of cutting grass. Continuing to operate
your lawnmower with the battery in this
discharged condition may reduce the life
and performance of your battery.

6. ADJUSTING ThE CUTTING hEIGhT

(See Fig. K)
wARNING! Stop, release switch lever
and wait until the motor stops before
adjusting height. The blades continue to rotate
after the machine is switched off, a rotating
blade can cause injury.
CAUTION: Do not touch rotating blades.
For the first cutting of the season, a high
cutting adjustment should be selected. The
lawnmower can be set to 6 cutting heights
between 20mm and 70mm. For this purpose,
move the cutting height adjustment lever
outwards then adjust to the preferred position.
7. GRASS BAG FILLING INDICATOR
(See Fig. L)
To remind you immediately to empty when
the grass collection bag is full, the mower
provides an indicator on the top of bag to
show the collection status. And you can follow
as below:
) are illuminated, the
) is illuminated,
EN
15