Table of Contents
Advertisement
<3> Make sure that the parts board (X2) is wired as shown in Figure 3-13.
<4> Remove the parts board that is mounted in the IE-780338-NS-EM1's X2 socket.
<5> Connect the parts board from <2> above to the socket from which the parts board was removed (from
<4> above). Check the pin 1 mark to make sure the board is mounted in the correct direction.
<6> Connect the IE-780338-NS-EM1 to the IE-78K0-NS or IE-78K0-NS-A.
The above steps configure the following circuit and enable supply of the clock from the mounted resonator
to the emulation device.
10 MΩ
HCU04
4
11
3
CB
12
Remarks 1. The sections enclosed in broken lines indicate parts that are attached to the parts board.
2. There is JP8 on the IE-78K0-NS or IE-78K0-NS-A.
30
CHAPTER 3 INSTALLATION
HCU04
9 8
5
Target
Rx
system
10
13
CA
2
User's Manual U16214EJ1V0UM
IE-78K0-NS or IE-78K0-NS-A side
(Emulation device)
1 3 5
JP8
2 4 6
Advertisement
Table of Contents
