Ground Terminal - Generac Power Systems GTH760 Service Manual

SeCTIoN 13: eNGINe ASSeMblY
b. Torque M6 screws to 4.5 Nm (40 in. lbs.).
c. Connect ignition ground wire to ignition ground terminal
in backing plate (see Figure 13-19).

GROUND TERMINAL

Figure 13-19. Ground Terminal
2. Assemble governor lever to governor arm. DO NOT tighten
at this time.
3. Install speed adjust assembly (refer to Section 4).
a. Torque screws to 6.0 Nm (53 in. lbs.).
4. Install exhaust.
a. Torque screws to 19 Nm (168 in. lbs.).
5. Install fan and retaining ring.
a. Torque screws to 21.7 Nm (192 in. lbs.).
6. Install blower housing.
a. Torque screws to 4.5 Nm (40 in. lbs.).
7. Install rotating screen.
a. Torque screws to 1.9 Nm (17 in. lbs.).
8. Install intake manifold assembly.
a. Torque bolts to 19 Nm (168 in. lbs.).
9. Install finger guard.
a. If engine is equipped with hex head screws, torque screws
to 4.5 Nm (40 in. lbs).
b. If engine is equipped with finger screws, tighten screws
by hand to approximately 1.3 Nm (12 in. lbs.).
10. Connect governor linkage and speed control linkage (refer
to Section 4).
11. Install spark plugs.
a. Torque spark plugs to 19 Nm (168 in. lbs.).
AdjuST GoverNor
Note: Refer to Section 4, Page 4-3 for Static Governor
Adjustment.
*
wArNING: beFore STArTING or ruNNING eNGINe,
static adjustment of the governor must be com-
pleted! Failure to make the static adjustments
first could result in engine overspeeding which
may result in engine damage, property damage or
personal injury.
13-6