Table of Contents
Advertisement
(2) Unloading the paper
The paper can be unloaded in two ways.
Move the head up lever toward
the paper out by hand in the forward direction (feeding direction)
or in the reverse direction.
Operate the paper feed mechanism to discharge the paper from
the printer. Move the head up lever to the head up position
remove the paper toward the front.
•
(Notes)
Operations other than those listed above could cause im-
proper paper feeding and jamming, and could cause
breaking of the head heating elements.
•
Never pull the paper out without using the head up lever,
regardless of the direction, forward or reverse.
(3) Removing paper after a paper jam
If a paper jam occurs, follow the procedure below.
Put the head-up lever in the
spacing between the head and platen rollers so that you can
easily check for a paper jam.
Remove a jammed paper by hand.
Return the head-up lever in the
When a tool such as tweezers, is used to remove paper chips, take
care not to touch the heating elements of the head with the tool.
Since the head is still hot just after the operation printing is stopped,
wait a while for the head to cool down.
CHAPTER 4. MAINTENANCE
To maintain proper performance of the printer for a long period of
time and to prevent trouble, carry out the maintenance and manage-
ment procedures as follows.
1. Cleaning
•
Removing stains
Wipe dirt off the head and platen rollers with a clean cloth satu-
rated with an alcoholic solvent (ethanol, methanol, IPA: Isopropyl
alcohol).
For cleaning the head part, refer to daily checks.
(Notes) Never use thinner, benzine, trichlene or ketone group sol-
vents, since they may damage or deteriorate rubber and
plastic parts.
•
Removing dust and fuzz
Cleaning by suction (with a vacuum cleaner) is desirable.
Suck up all the dust and fuzz.
(Notes) Check lubrication at various points after cleaning, and lubri-
cate with oil at the specified locations.
: Head up position and then pull
and
Cleaning position to widen the
Close position.
2. Inspection
The maintenance and inspection items for the printer are dividend
into 2 types. One is "Daily checks" for the person who uses the
printer, and the other is "Periodic checks" for someone with more
technical knowledge. Maintenance and inspections should be carried
out by properly qualified personnel.
(1) Daily checks
Check that the printer is used properly and kept in the good repair.
Daily check items
The specified paper is being used.
The paper has not become discolored.
Check print quality and if significant deterioration is found, clean
the head heating elements.
<Head cleaning method>
1) Place the head-up lever in the
is securely locked.
2) Wipe the heating element of the head and platen rollers clean with
a soft cloth or cotton pledget moistened with alcoholic solvent
(ethanol, methanol or IPA: isopropyl alcohol).
3) After making sure the alcoholic solvent has thoroughly evapo-
rated, undo the head-up lever and platen rollers in the
position.
If paper dust is attached to the platen roller surface, the paper
feeding power is reduced. Be sure to clean the platen roller sur-
face when cleaning the head.
The illustration shows the state when the PT-cover is removed for
explanation purposes only.
Cotton swab
Fig. Head and Platen roller cleaning
: Cleaning position. Make sure it
Close
Thermal head unit
Platen roller
Advertisement
Table of Contents
