Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Stabila LD 400
Summary of Contents for Stabila LD 400
-
Page 4: Symbols Used In This Manual
WARNING • Use of accessories from other manufacturers Indicates a potentially hazardous situation or without the express approval of Stabila. an unintended use which, if not avoided, could result • Deliberate or irresponsible behaviour on scaffol- in death or serious injury. -
Page 5: Limits Of Use
Also see section "Technical data". • To understand the safety instructions on the The Stabila LD 400 is designed for use in areas product and the instructions in the user manual. permanently habitable by humans, do not use the •... -
Page 6: Operation
Only use alkaline batteries. Precautions: If the instrument will not be used for a long Carry out periodic test measurements. time, remove the batteries as a protection against Particularly after the instrument has been subject to corrosion. Stabila LD 400 Start up... -
Page 7: Switching On/Off
Setting the instrument measurements. Press long until the desired unit is displayed. Make sure the Stabila LD 400 optic is kept clean and that there is no mechanical damage to the bumpers. Possible units: CAUTION:... -
Page 8: Single Distance Measurement
See drawing {F}. maximum distance from a specific measuring point, e.g. the determination of room diagonals (maximum value) or horizontal distance (minimum value). Switching on continuous measurement (see above). The corresponding maximum and minimum values are displayed. Stabila LD 400 Measuring... -
Page 9: Addition / Subtraction
(e.g. height). The value is displayed in the summary row, the individually measured values intermediate line 1. are displayed in intermediate lines 1 and 2. The result of the area measurement is displayed in the summary row, the two previously measured Functions Stabila LD 400... -
Page 10: Indirect Measurement
If the button is pressed for along time while measuring a distance, maximum or minimum conti- The distance to be measured flashes in the symbol. nuous measuring is activated. 1x briefly: takes a measurement of the distance Stabila LD 400 Functions... -
Page 11: Stake Out Function
0,10 m), the instrument starts to beep. When the point is reached, the beep sound changes and inter- mediate line 1 starts to flash. 1x briefly: distance measurement is interrupted and the instrument switches back to individual distance measuring mode. Functions Stabila LD 400... -
Page 12: Timer (Self-Triggering)
Outside of the range Select measurement of measurement distance within the range of measurement Error Cause Correction Error Hardware error Should this message remain active after switching the instru- ment off and on several times, please contact the dealerhip. Stabila LD 400 Appendix... -
Page 13: Technical Specifications
WARNING Autom. power off: Laser after 60 s The Stabila LD 400 conforms to the most strin- Instrument after 180 s gent requirements of the relevant standards and Illumination regulations. Folding out endpiece Yet. the possibility of the product causing interfe-... -
Page 14: Laser Classification
Do not stare into beam. Do not look into the laser Warranty beam. Make sure the laser is aimed above or below The Stabila LD 400 comes with a two year warranty eye level (particularly with fixed installations, in machines, etc.). - Page 15 Dispose of the product appropriately in accordance with the national regulations in force in your country. Adhere to the national and country specific regula- tions. All right reserved for changes (drawings, descriptions and technical specifications). Appendix Stabila LD 400...
Need help?
Do you have a question about the LD 400 and is the answer not in the manual?
Questions and answers