Advice Regarding The First Wash Cycle; Technical Data - Hotpoint LFK 7M124 Operating Instructions Manual

*
Anti-condensation strip
After installing the dishwasher, open the door and stick the
adhesive transparent strip under the wooden shelf in order
to protect it from any condensation which may form.

Advice regarding the first wash cycle

After the installation, remove the stoppers from the racks
and the retaining elastic elements from the upper rack,
if any.Immediately before running the first wash cycle,
completely fill the salt dispenser with water and add only
then approximately 1 kg of salt
aid and refined salt)
. The water may overflow: this is normal
and is not a cause for concern. Select the water hardness
(see chapter entitled Rinse aid and refined salt).
value
the salt has been poured into the machine, the LOW SALT
*
indicator light switches off.
If the salt container is not filled, the water softener and
the heating element may be damaged as a result.
Assistance
Before contacting Assistance:
• Check whether the problem can be resolved using the
Troubleshooting guide (see Troubleshooting).
• Restart the programme to check whether the problem has
ceased to exist.
• If the problem persists, contact the Authorised Technical
Assistance Service.
Never use the services of unauthorised technicians.
Please have the following information to hand:
• The type of malfunction.
• The appliance model (Mod.).
• The serial number (S/N).
This information can be found on the appliance data plate
(see Description of the appliance) .
(see chapter entitled Rinse
- After
The machine has a buzzer/set of tones
dishwasher model
) to inform the user that a command has
been implemented: power on, cycle end etc.
The symbols/indicator lights/LEDs on the control panel/
display may vary in colour and may have a flashing or fixed
(depending on the dishwasher model)
light

Technical data

width 60 cm
height 85 cm
Dimensions
depth 60 cm
14 standard place-settings
Capacity
0,05 ÷ 1MPa (0.5 ÷ 10 bar)
Water supply pressure
7,25 – 145 psi
Power supply voltage See appliance data plate
Total absorbed power See appliance data plate
Fuse See appliance data plate
This dishwasher conforms to the
following European Community
Directives:
-2006/95/EC (Low Voltage)
-2004/108/EC (Electromagnetic
Compatibility)
-2009/125/EC (Comm. Reg.
1016/2010) (Ecodesign)
-97/17/EC (Labelling)
-2012/19/EU Waste Electrical
and Electronic Equipment
(WEEE)
*
Only available in selected models.
(depending on the
EN
.
5