Hotpoint LFK 7M124 Operating Instructions Manual page 11

Special wash cycles and Options
Notes:
Optimum performance levels when using the "Fast" and "Express
30'" cycles can be achieved by respecting the specified number
of place settings.
To reduce consumption, only run the dishwasher when it is full.
Note for Test Laboratories: for information on comparative EN
testing conditions, please send an email to the following address:
ASSISTENZA_EN_LVS@indesitcompany.com
Wash options*
The OPTIONS may only be set, changed or reset after
the wash cycle has been selected and before the Start/
Pause button has been pressed.
Only the options whic are compatible with the type of wash
cycle set may be selected. If an option is not compatible
with the selected wash cycle
corresponding symbol flashes rapidly 3 times.
If an option is selected which is not compatible with another
(previously selected) option, it will flash 3 times and switch
off, while the most recently selected option will remain active.
To deselect an option which has been set by mistake, press
the corresponding button again.
Delayed start
It is possible to delay the start time of the wash cycle
by 3, 6 or 9 hours:
1:After selecting the desired wash cycle and any other
options, press the DELAYED START button. the indicator
light will illuminate.
2: Select the desired delay time by pressing the Delayed
Start button repeatedly. The wash phase (3 hours), the
drying phase (6 hours) and end (9 hours) indicator lights
will illuminate in succession.
If the Delayed Start button is pressed again, the option is
deselected and the indicator light switches off.
3. After the selection process, the countdown will begin if
the Start/Pause button is pressed. The selected delay period
indicator light flashes and the Start/Pause button stops
flashing (fixed light).
3. Once this time has elapsed, the DELAYED START indicator
light switches off and the wash cycle begins.
The Delayed Start function cannot be set once a wash
cycle has been started.
*
Only available in selected models.
(see Table of wash cycles)
, the
Extra drying
To improve the dryness level of the crockery, press
the EXTRA DRYING button; the indicator light will illuminate.
If it is pressed again the option will be deselected.
A higher temperature during the final rinsing and a longer
drying phase improve the dryness level.
The EXTRA DRYING option increases the duration of
the wash cycle.
Half load
If there are not many dishes to be washed, a half
load cycle may be used in order to save water, electricity
and detergent. Select the wash cycle and press the HALF
LOAD button: the indicator light will illuminate.
Press the HALF LOAD button to deselect this option.
Remember to halve the amount of detergent.
Multi-functional tablets (Tabs)
This option optimises washing and drying results.
When using multi-functional tablets, press the MULTI-
FUNCTIONAL TABLETS button; the corresponding indicator
will light up. If the button is pressed again, the option will be
deselected.
The "Multi-functional tablets" option results in a
longer wash cycle.
The use of tablets is only recommended for models
having this option and it is not recommended with wash
cycles which do not specify the use of multi-functional
tablets.
EN
11