Fender Passport Conference Owner's Manual page 10

Master Controls
MASTER VOLUME
1 2
MASTER VOLUME — Use to adjust the overall loudness of
your Fender Passport Conference. When this knob is rotated
VOLUME VOLUME
fully counter-clockwise, there will be no sound coming out of
the Passport speakers.
Channel Controls
TONE TONE
SIGNAL PRESENT / CLIP INDICATOR —
This LED illuminates green to indicate an
PAD PAD
input signal level is present in the channel.
It turns yellow when the input signal level
INPUT INPUT
gets closer to clipping (-10dB from clip)
and red during clipping (distorting). For
best performance, set the VOLUME and
TONE controls so that the LED is yellow or
INPUT INPUT
green. If the LED is turning red, reduce the
VOLUME or TONE knob settings. If the LED
is still turning red after adjusting VOLUME/
TONE, press the PAD
LEVEL
PHONES
OUT
VOLUME — Use to adjust each channel's
volume relative to the loudness of the other
channels.
TONE — Use to adjust the tone character of each channel. In
the center detent position the TONE control is "flat" and has
no effect on the channel's sound.
PAD — Press in to reduce the input sensitivity of the channel
by 20dB if the source level is too high (see
10
3 4/5
VOLUME VOLUME
TONE TONE
1
PAD STEREO INPUT
VOLUME
INPUT
L/MONO INPUT
TONE
INPUT RIGHT INPUT
button in.
PAD
POWER
INPUT
INPUT
above).
PHONES
OUT
Mono Channel Inputs
& XLR & 1/4" — Connect microphones,
instruments, or mono line-level sources
into these jacks. Both XLR and 1/4"
inputs are compatible with microphone
or line inputs. The PAD switch may be
required for line-level signals, to prevent
clipping.
♫
It is okay to use both inputs at the same time, but the signal
levels of each of the inputs need to be adjusted at their sources.
MASTER VOLUME
Stereo Channel Inputs
1/8" STEREO — Plug your CD player, MP3
player, computer audio interface, or other
line-level, stereo source into this jack. NOTE:
Using this jack will mute the L/MONO and
2 3
RIGHT input jacks.
VOLUME 1/4" LEFT (MONO) / RIGHT — Plug a line- VOLUME
level stereo source that requires separate
1/4" connections for each channel, into these
jacks. You can also use the stereo channel as
TONE TONE
a mono channel by using only the L/MONO
jack (mono output will be through both speakers).
PAD PAD
STEREO /
INPUT INPUT
Connect recording equipment or
headphones here. MASTER VOLUME
does not effect this output, but
each of the channel controls do.
INPUT INPUT
LEVEL — Adjusts the output level of the STEREO / PHONES
OUT jack to accommodate the input level requirements of
your external equipment.
LEVEL
POWER — The Power LED will illuminate
green when the Passport is turned on. If
audio output from the Passport shuts off,
the unit may have shutdown to protect
itself from electrical or thermal trouble.
The Passport will reset itself as soon as the
problem has been resolved. If the Passport will not reset,
check the FUSE
MASTER VOLUME
1 2
VOLUME VOLUME VOLUME
TONE TONE TONE
PAD PAD PAD
MASTER VOLUME
INPUT INPUT INPUT
4/5
VOLUME
INPUT INPUT INPUT
1 2
TONE
VOLUME VOLUME VOLUME
LEVEL
PHONES
OUT
Front Panel Output
STEREO INPUT
TONE TONE TONE
PHONES OUT —
L/MONO INPUT
PAD PAD PAD
RIGHT INPUT
INPUT INPUT INPUT
POWER
INPUT INPUT INPUT
Power LED
LEVEL
PHONES
OUT
in the POWER SOCKET.
TONE TONE
PAD PAD
INPUT INPUT
INPUT INPUT
MASTER VOLUME
3 4/5
VOLUME
LEVEL
PHONES
OUT
1 2 3
TONE
VOLUME VOLUME VOLUME
STEREO INPUT
TONE TONE TONE
L/MONO INPUT
PAD PAD PAD
RIGHT INPUT
3 4/5
INPUT INPUT INPUT
VOLUME
POWER
INPUT INPUT INPUT
TONE
LEVEL
PHONES
OUT
STEREO INPUT
L/MONO INPUT
RIGHT INPUT
POWER