iKEY-AUDIO G3 Instruction Manual page 15

Input Level
Signal Meters
Solution: Slightly scale back Rec. Level jog wheel so the meter
does not appear red
Solution- Raise the Rec. Level jog wheel all the way and lower
the input gain until the signal barely peaks and can be scaled
back so it does not appear red.
Connections and System Control
15
Conexiones y Control de sistema • Connexions & Utilisation • Anschlüsse und Systemeinstellungen
Output Result
clipping/
distortion
clean
recording
clipping at
mid-recording
level
fig. 1.8
Solution- Turn the Rec. Level jog wheel all the way up and
raise the input gain until the signal barely peaks and can be
scaled back.
*Note: If your recording is not being stored correctly, you may have
to raise or lower the signal coming from your source directly if pos-
sible.
Recording a File
Once your bit rate format, levels and stereo/mono settings
have been made, you are ready to record. In record mode,
simply press the RECORD button to start recording. A light
will flash below the record button to indicate that the unit is
recording.
To pause a recording, press the RECORD button again.
low level
recording