Table of Contents
Advertisement
Available languages
Available languages
• Performance may be affected if the voltage varies by 10% or
more. Operating the refrigerator with insufficient power can
damage the compressor. Such damage is not covered under
your warranty.
• Do not plug unit into an outlet controlled by a wall switch or pull
cord to prevent the refrigerator from being turned off accidentally.
Important
To turn off power to your refrigerator, unplug the power cord
from the wall outlet.
Installation
Location
• Choose a place that is near a grounded electrical outlet. Do Not
use an extension cord or an adapter plug.
• If possible, place the refrigerator out of direct sunlight and away
from the range, dishwasher or other heat sources.
• The refrigerator must be installed on a floor that is level and
strong enough to support a fully loaded refrigerator.
• Consider water supply availability for models equipped with an
automatic ice maker.
Installation
Caution
Do Not install the refrigerator where the temperature will drop
below 13°C (55°F) or rise above 43°C (110°F). The
compressor will not be able to maintain proper temperatures
inside the refrigerator. Do Not block the toe grille on the lower
front of your refrigerator. Sufficient air circulation is essential for
the proper operation of your refrigerator.
Installation Clearances
Allow the following clearances for ease of installation and plumbing
and electrical connections:
Sides & Top
10 mm (3/8 inch)
Back
25 mm (1 inch)
Door Opening
Your refrigerator should be positioned to allow easy access to a
counter when removing food. For best use of drawers and freezer
baskets, the refrigerator should be in a position where both the
refrigerator and freezer doors can be fully opened.
Downloaded from Fridge-Manual.com Manuals
Note
If your refrigerator is placed with the door hinge side against a
wall, you may have to allow additional space so the door can be
opened wider.
Removing And Replacing The Toe Grille:
To remove the toe grille:
Open the freezer and refrigerator compartment doors.
1
Remove the screw from each side of the toe grille.
2
Pull the toe grille forward and lift it off.
3
Reverse these instructions to install the grille.
Leveling
All four corners of your refrigerator must rest firmly on a solid floor.
Your refrigerator is equipped with adjustable front rollers to help
level your unit. To ensure proper door seal and assist door closing,
the refrigerator should be tilted 6 mm (1/4 inch), front to back.
To level your refrigerator:
Remove toe grille (see above) to access the front rollers.
1
Adjust the rollers by turning each roller adjustment bolt with a
2
wrench or flat-blade screwdriver until the refrigerator is level and
stable.
Check both doors to be sure seals touch cabinet on all four sides.
3
Replace the toe grille.
4
Tips:
• If the freezer door is higher than the refrigerator door, raise the
right corner and/or lower the left corner until the doors align
across the top of the cabinet.
• If the refrigerator door is higher than the freezer door, raise the
left corner and/or lower the right corner until doors align across
the top of the cabinet.
Removing The Doors
If your refrigerator will not fit through an entrance area, you can
reduce its size by removing the doors. Check first by measuring the
entrance.
Required Tools
You will need the following tools:
• Phillips
head screwdriver.
TM
• Socket wrench set OR adjustable wrench.
3
Advertisement
Table of Contents
