Table of Contents
Advertisement
Chapter 2
Configuration and Installation
Hardware Installation
Caution
The 7340 is a sensitive electronic device shipped in an antistatic bag. Open only
at an approved workstation and observe precautions for handling electrostatic-sensitive
devices.
Note
When adding or removing a controller from a Windows 2000/NT/XP system, you
must be logged on with administrator-level access. After you have restarted the system, you
may need to refresh Measurement & Automation Explorer (MAX) to view the new
controller.
To protect yourself and the computer from electrical hazards, the computer must
Caution
remain unplugged until the installation is complete.
NI 7340 User Manual
meters and measurements on primary overcurrent protection devices
and on ripple control units.
Install the 7340 in any open compatible expansion slot in the PXI or PCI
system. Appendix A, Specifications, lists the typical power required for
each controller.
The following instructions are for general installation. Consult the
computer user manual or technical reference manual for specific
instructions and warnings.
♦
PXI-7340
1.
Power off and unplug the chassis.
2.
Choose an unused +3.3 V or +5 V peripheral slot and remove the filler
panel.
3.
Touch a metal part on the chassis to discharge any static electricity that
might be on your clothes or body. Static electricity can damage the
controller.
4.
Insert the PXI controller into the chosen slot. Use the injector/ejector
handle to fully inject the device into place.
5.
Screw the front panel of the PXI controller to the front panel mounting
rails of the chassis.
6.
Visually verify the installation.
7.
Plug in and power on the chassis.
2-4
ni.com
Advertisement
Table of Contents
