Plug Replacement (Uk & Ireland Only); Maintenance; Environmental Protection - Worx WU643 Manual

test run on scrap material.
Use only good quality sand paper.
The sand paper controls the sanding efficiency, not the amount of
force you apply to the tool. Excessive force will reduce the sanding
efficiency and cause motor overload. Replacing the sand paper
regularly will maintain optimum sanding efficiency.

Maintenance

Remove the plug from the socket before carrying out any
adjustment, servicing or maintenance.
Your power tool requires no additional lubrication or maintenance.
There are no user serviceable parts in your power tool. Never use
water or chemical cleaners to clean your power tool. Wipe clean with
a dry cloth. Always store your power tool in a dry place. Keep the
motor ventilation slots clean. Keep all working controls free of dust.
Occasionally you may see sparks through the ventilation slots. This is
normal.
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in order
to avoid a hazard.

Environmental protection

Waste electrical products should not be disposed of with
household waste. Please recycle where facilities exist. Check
with your local authorities or retailer for recycling advice.
Plug replacement
(UK & Ireland only)
If you need to replace the fitted plug then follow the instructions
below.
IMPORTANT
The wires in the mains lead are colored in accordance with the
following code:
BlUE =NEUTRAl
As the colors of the wires in the mains lead of this appliance may not
correspond with the colored markings identifying the terminals in
your plug, proceed as follows. The wire which is colored blue must
be connected to the terminal which is marked with N. The wire which
is colored brown must be connected to the terminal which is marked
with L.
Note: If a moulded plug is fitted and has to be removed take great
care in disposing of the plug and severed cable, it must be destroyed
to prevent engaging into a socket.
Connect
Blue to N
(neutral)
Outer sleeve
firmly clamped
10
BROWN = lIVE
WARNING!
13 Amp fuse approved
to BS1362 Never connect live
or neutral wires to
the earth terminal
Brown L (live)
of the plug. Only
fit an approved
13ABS1363/A plug
Cable grip
and the correct
rated fuse.