Casio WK-200 User Manual page 21

WK200_e.book 19 ページ ２００８年５月１６日 金曜日 午後８時４４分
■ How sampled sounds are played
Pressing Middle C (C4) will play back the original sound. The
keys to the left and right of C4 play the sound at different
pitches.
C4
Looping a Sampled Sound
You can use the following procedure to loop a sampled sound
so it continues to repeat, as you play on the Digital Keyboard.
1.
bq
Press .
2.
cs
While holding down
This enters repeat standby.
F u n k
3.
bt
Press the button ( to
the melody sampling tone number you want to
select.
This will start looped playback of the selected sound.
To select this tone number:
WK-500 WK-200
671 571
672 572
673 573
674 574
675 575
4.
Press the same button again to stop playback.
5.
co
Press to return to the screen that was
displayed before step 2 of this procedure.
Sampling Sounds and Playing Them on the Digital Keyboard
co
, press .
8 B t
Lights
cn
) that corresponds to
Press this button:
bt
ck
cl
cm
cn
Changing the Volume of Sampled Sound
Looped Playback
You can use the following procedure to change the volume
level of the looped playback of each sampled sound, if you
want.
1.
Press the button of the sampled sound whose
volume you want to change (
• This will cause the sounds loop to sound.
2.
While the loop is sounding hold down the same
sampled sound button (
any keyboard key.
• Pressing the keyboard key quickly will increase sample
sound volume, while pressing slowly will decrease
volume.
3.
After the sampled sound is at the volume level
you want, release its button (
bt cn
to ).
bt cn
to ) as you press
bt cn
to ).
E-19