Mechanical Dimensions; Power Requirements; Isolation Voltage - National Instruments FIELDPOINT cFP-PWM-520 Operating Instructions Manual

Mechanical Dimensions

Figure 5 shows the mechanical dimensions of the FP-PWM-520
installed on a terminal base. If you are using the cFP-PWM-520,
refer to your Compact FieldPoint controller user manual for the
dimensions and cabling clearance requirements of the Compact
FieldPoint system.
109.5 mm
(4.31 in.)
Figure 5. FP-PWM-520 Mechanical Dimensions

Power Requirements

Power from network module ............ 1 W

Isolation Voltage

Isolation voltage is verified by a dielectric withstand test.
Channel-to-ground isolation
Continuous ................................. 250 V
Dielectric withstand.................... 2,300 V
Channel-to-channel isolation ............ None
Environmental
FieldPoint modules are intended for indoor use only. For outdoor
use, they must be mounted inside a sealed enclosure.
Operating temperature ...................... –40 to 70 °C
Storage temperature .......................... –55 to 85 °C
Humidity ........................................... 10 to 90% RH,
Maximum altitude............................. 2,000 m
Pollution Degree ............................... 2
FP-PWM-520 and cFP-PWM-520
91.44 mm
(3.60 in.)
rms
Category II
rms
noncondensing
14
107.19 mm
(4.22 in.)
, Measurement
, 5 s max
ni.com