Electrolux EN3481AOX User Manual page 50

50 www.electrolux.com
C
C
1
2
B
B
• Take out the cable form the door end
cap cover and place it into the upper
hinge.
• Re- screw the hinge.
• Connect the cable to the connecting
point in the front panel.
• Put back the top front covers on both
sides (2)
• Place the display cable, which is cur-
rently disconnected, into the cable
holder in the door end cap then put
back the door end cap cover.
• Remove the covers (B). Remove the
cover pins (A).
• Unscrew the handles (C) and fix them
on the opposite side. Place the upper
handle to the lower door and the lower
handle to the upper door
A
• Re-insert the cover pins (A) on the op-
posite side.
Do a final check to make sure that:
• All screws are tightened.
• The magnetic seal adheres to the cabi-
A
net.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly to
the cabinet. In that case, wait for the nat-
ural fitting of the gasket.
In case you do not want to carry out the
above mentioned operations, contact the
nearest After Sales Service Force. The Af-
ter Sales Service specialist will carry out
the reversibility of the doors at your cost.