Remote Control Preparation; Inserting The Batteries - Panasonic CS-CE7GKEW Operating Instructions Manual

HOW TO OPERATE

REMOTE CONTROL PREPARATION

REMOTE CONTROL PREPARATION
REMOTE CONTROL PREPARATION REMOTE CONTROL PREPARATION

Inserting the batteries

Pull out
Close
• The batteries can be used for approximately 1 year.
Replace the batteries when the remote control display or
transmission signal becomes weak.
Setting the current time
Press
MODE OPERATION MODE OPERATION
MODE OPERATION MODE OPERATION
Select Turn on
AUTO HEAT
DRY COOL
AUTO MODE - FOR YOUR CONVENIENCE
• Unit selects the operation mode according to temperature
setting, outdoor and room temperature.
• Operation mode is reselected every 30 minutes. During
operation mode selection the power indicator blinks.
HEAT MODE - TO ENJOY WARM AIR
• In heat mode, it takes a while for the unit to warm up. The
power indicator blinks during this operation.
COOL MODE - TO ENJOY COOL AIR
DRY MODE - TO DEHUMIDIFY THE
ENVIRONMENT
• During soft dry operation, the indoor fan operates at low
fan speed to give a very gentle cooling operation.
● The range of temperature for selection is
16°C ~ 30°C.
● Operating the unit within the recommended
temperature could induce energy saving.
HEAT MODE : 20°C ~ 24°C.
COOL MODE : 26°C ~ 28°C.
DRY MODE : 1°C ~ 2°C lower than room temperature.
4
Insert AAA or
R03 batteries
Set time
Confi rm
Adjust
temperature
REMOTE CONTROL TRANSMITTER
• Make sure it is not
obstructed.
• Certain fl uorescent lights
may interfere with signal
transmission. Please
consult your nearest
dealer.
INDICATOR INDICATOR
INDICATOR INDICATOR
Maximum distances : 8m
Remote
control
display
Notes:
• Press RESET button to restore the remote control's
default setting.
• For normal operation, the
in use.
• While using remote control, please be aware of the OFF
indication on the remote control display to prevent the unit
from starting / stopping improperly.
• PATROL operates automatically once the unit is switched on
with button.
RECEIVER RECEIVER
RECEIVER RECEIVER
and RESET buttons are not