Remote Control Preparation; Inserting The Batteries - Panasonic CU-E18GFE-1 Operating Instructions Manual

HOW TO OPERATE

REMOTE CONTROL PREPARATION

REMOTE CONTROL PREPARATION
REMOTE CONTROL PREPARATION REMOTE CONTROL PREPARATION

Inserting the batteries

Pull out
Close
• The batteries can be used for approximately 1 year.
Replace the batteries when the remote control display or
transmission signal becomes weak.
Setting the current time
TIMER
ON
1 2
OFF
Press
CHECK CLOCK
MODE OPERATION MODE OPERATION
MODE OPERATION MODE OPERATION
OFF/ON
Select Turn on
AUTO HEAT
DRY COOL
AUTO MODE - FOR YOUR CONVENIENCE
• Unit selects the operation mode according to temperature
setting, outdoor and room temperature.
• Operation mode is reselected every 30 minutes. During
initial operation mode selection, the power indicator blinks.
HEAT MODE - TO ENJOY WARM AIR
• In heat mode, it takes a while for the unit to warm up. The
power indicator blinks during this operation.
COOL MODE - TO ENJOY COOL AIR
DRY MODE - TO DEHUMIDIFY THE
ENVIRONMENT
• During soft dry operation, the indoor fan operates at low
fan speed to give a very gentle cooling operation.
● The range of temperature for selection is 16°C ~ 30°C.
● Operating the unit within the recommended
temperature could induce energy saving.
HEAT MODE : 20°C ~ 24°C.
COOL MODE : 26°C ~ 28°C.
DRY MODE : 1°C ~ 2°C lower than room temperature.
4
Insert AAA or
R03 batteries
Set time
SET
Confi rm
3
CANCEL
RESET
TEMP
Adjust
temperature
(Green)
(Orange)
(Orange)
REMOTE CONTROL TRANSMITTER
• Make sure it is not obstructed.
• Certain fl uorescent lights may interfere with signal transmission.
Please consult your nearest dealer.
Maximum distances : 8m
Notes:
• Press button to restore the remote control's default
setting.
• While using remote control, please be aware of the OFF
indication on the remote control display to prevent the unit
from starting / stopping improperly.
(Orange)
(Orange)
INDICATOR INDICATOR
INDICATOR INDICATOR
Remote
control
display