Adjusting Audio And Video Settings; Using The Setup Screen Menus - Pioneer DV-626D Operating Instructions Manual

Adjusting Audio
and Video
Settings

Using the Setup Screen Menus

The procedure on this page describes how to operate
the menus on the Setup screen. These menus are used
to set and adjust a number of system settings. The
various functions that can be adjusted are covered
throughout this manual. The procedure on this page
provides a basic outline for using the Setup screen
menus.
When setting up for the first time
It is recommended to set up player using the Setup
Navigator (page 21). If you selected "Not Used" when
the Setup Navigator appears, you may still set up the
player using the Setup Navigator in the General menu
screen.
If you choose not to use the Setup Navigator, be sure to
make the necessary settings in the Setup screen
Audio 1, Audio 2, Video, and Language menus as
described on the following pages.
Some DVDs start playing automatically when loaded in
the player. If a DVD has been loaded, be sure to press
STOP 7 before proceeding.
Note
If the Setup screen is opened during playback of a DVD being
viewed in the letter box format, the screen may switch to the
wide screen format. This is not a malfunction, and the screen
will return to normal when the Setup screen is closed.
ST ANDBY
POWER
1
2
4,5
4
1
8
1
Press POWER on the front panel to turn the
player on.
0
4 1 ¡ ¢
7 8 3
5
¢
3,6
3 ¡
7 e E
2
Press SETUP.
The Setup screen appears.
(Example)
2 Video Language
Audio1
Dolby Digital Out – Dolby Digital
DTS Out – Off
96kHz PCM Out – 96kHz 3 48kHz
MPEG Out – MPEG 3 PCM
Setup audio
Digital output format/tone adjust
Move
3
Use the cursor buttons (2/3) to select the
menu you want.
As each menu is selected with the cursor, the
settings appear below the menu heading.
4
Press the cursor button (∞) to enter the
menu.
The top item within the menu becomes highlighted.
(Example)
Audio1 2 Video Language
Dolby Digital Out
DTS Out -
96kHz PCM Out – 96kHz 3 48kHz
MPEG Out – MPEG 3 PCM
Switch Dolby Digital audio mode
Move
5
Use the cursor buttons (5/∞) to select the
setting you want to change.
The options available for each setting appear to the
right when the setting is selected. The current
setting appears with the setting indicator lit.
6
Press the cursor button (3) to enter the
setting options.
(Example)
2 Video Language
Audio1
Dolby Digital Out
DTS Out -
96kHz PCM Out – 96kHz 3 48kHz
MPEG Out – MPEG 3 PCM
Output Dolby Digital
Move
• Not all menu options can be changed while a disc
is playing. In these cases, the options appear
grayed out on the screen and cannot be adjusted.
To change these settings, press STOP 7 first
before pressing SETUP.
• Operating the menu after pressing STOP 7 may
cancel the resume function.
• Some menu options are not immediately
effective if set while a disc is playing. To make
these settings effective, stop playback and then
start again, or change the settings while the disc
is stopped.
General
Exit
SETUP
General
Dolby Digital
Dolby Digital 3 PCM
Exit
SETUP
General
Dolby Digital
Dolby Digital 3 PCM
Exit
SETUP
continued
29
En