Walk Test - Optex HX-40 Installation Instructions Manual

When using the bracket
In
2
In
Magnet
switch
Install the bracket and the main unit to
4
the wall surface.
3

WALK TEST

Set the DIP switch 1 (LED ON/OFF) to
1
"ON".
Note>>
The switch is set "ON" by factory
default.
If the LED indication is not required at all
3
times, set the DIP switch 1 (LED ON/
OFF) to "OFF".
1
Fix
Tilt the bracket about 45° and
pass through the wire.
In
4
6
3
Wiring
Out
sponge pad
Connect the universal magnet switch wiring
5
to the tamper terminal of the main unit.
Check that the detector detects an
2
object in the intended detection area.
The installation has been successful if
the LED lights for two seconds after a
person walks into the detection area.
Note>>
For the walk test, move more than 1.0 m
(3'3") away from the detector.
- 12 -
Detected
Not detected
5
Out