Advertisement
Quick Links
900
SITdefault
Saab 9-5
Parking assistance (SPA)
Accessories Part No.
32 026 005
MONTERINGSANVISNING · INSTALLATION INSTRUCTIONS
MONTAGEANLEITUNG · INSTRUCTIONS DE MONTAGE
Group
9:89-33
SCdefault
Installation instructions
Date
Instruction Part No.
Jan 07
32 026 006
Saab 9-5
Replaces
E930A513
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Saab 32 026 005
Summary of Contents for Saab 32 026 005
- Page 1 Installation instructions SCdefault MONTERINGSANVISNING · INSTALLATION INSTRUCTIONS MONTAGEANLEITUNG · INSTRUCTIONS DE MONTAGE SITdefault Saab 9-5 Parking assistance (SPA) Accessories Part No. Group Date Instruction Part No. Replaces 32 026 005 9:89-33 Jan 07 32 026 006 E930A513 Saab 9-5...
- Page 2 8 Adapter harness 9 Connector 10 Cable tie (x20) 11 Cable tie (x2) 12 Cable tie 13 Cable tie, rubber grommet 14 Rubber grommet 15 Fuse holder with 7.5 A fuse 16 Fuse holder with 10 A fuse Saab 9-5...
- Page 3 (x2) in the rear edge of the body. · Loosen and move aside the right-hand side trim (D) in the luggage compartment and remove the insulation pads (x2) in the rear edge of the body. Saab 9-5...
- Page 4 3 screws. · Remove the side bolster (H) by first pulling its top edge so that the lock tongue releases. Then unhook the lower edge. · Remove the screws in the top edge of the side trim (I). Saab 9-5...
- Page 5 The outer bolts (B) are fitted in loose nut plates. 8 Lower the car. 9 With help from an assistant, pull the bumper out from the clips. Lift the bumper out backwards. Important Place the bumper on a soft, clean surface. Saab 9-5...
- Page 6 16 Pre-route the wiring harness in the centre foam section (F). The connector comes out on the left-hand side. Connect the wiring harness to the sensors. WARNING Check that the wiring harness is not trapped. Incorrect fitting could damage the wiring harness and cause a short-circuit/fire. Saab 9-5...
- Page 7 4 Blue (BU) 5 Orange (OG) 6 Grey (GY) Important Check that the cable terminals lock firmly and that the whole of the seal is in contact against the con- nector. Be careful so that the seals are not damaged. Saab 9-5...
- Page 8 Affix tape and fit a new cable tie (B) on the rubber grommet. · Fit the left-hand mounting bracket (A) for the bumper shell under the left-hand tail lamp. The wiring harness must be routed inside the bracket (D). Saab 9-5...
- Page 9 29 Cars with towbar: Plug in the connector for the towbar wiring harness. 30 Cars with towing bracket: Fit the bolts (C) and nut plates holding the towing bracket to the body. Tightening torque 40 Nm (30 lbf ft) Saab 9-5...
- Page 10 (C). WARNING Check that the wiring harness is not trapped. Incorrect fitting could damage the wiring harness and cause a short-circuit/fire. Important Secure the wiring harness so that there is no risk of chafing and rattling. Saab 9-5...
- Page 11 CB - Cable tie with clip for mounting in holes. WARNING Check that the wiring harness is not trapped. Incorrect fitting could damage the wiring harness and cause a short-circuit/fire. Important Secure the wiring harness so that there is no risk of chafing and rattling. Saab 9-5...
- Page 12 35 Remove the centre console side trim (C) on the left-hand side. 36 RHD: Remove the panel lower section (D) and the centre console side trim (E) on the driver's side. 37 Remove the cover (F) for the fuse box. Saab 9-5...
- Page 13 Turn and lift up the theft protection antenna unit (G) (bayonet fitting) from the ignition switch and unplug the connector. Insert the key and select neutral position. · Detach the switch (H) for the power windows and unplug the connectors. Saab 9-5...
- Page 14 · Fold aside the front carpets and undo the front screws (J). · Undo the rear screws (K). · Lift up and remove the centre console (L). · Cut apart the carpet (M). Saab 9-5...
- Page 15 Route the thin section of the wiring harness (RD and VT cables) on under the dashboard and up to the fuse box. Saab 9-5...
- Page 16 - Fit the fuse just removed into the fuse holder (B). · Unplug and separate the front connector (C), located between the seats, and connect the adapter harness between the separated con- nector (C). · Position the connectors (C, D). Saab 9-5...
- Page 17 WARNING Check that the wiring harness is not trapped. Incorrect fitting could damage the wiring harness and cause a short-circuit/fire. Important Secure the wiring harness so that there is no risk of chafing and rattling. Saab 9-5...
- Page 18 Fold up the carpets. · Lift back the upper section of the centre con- soles. At the same time, carefully route the cables into place. · Fit the screws (I) holding the upper section of the centre console. Saab 9-5...
- Page 19 Fit the storage compartment/ashtray (B). · Manual transmission: Fit the gear lever gai- ter (A). Automatic transmission: Fit the surround around the gear lever housing. · Plug in the connector and fit the theft protec- tion antenna unit (G). Saab 9-5...
- Page 20 45 Fit the centre console side trim (C) on the left- hand side. 46 Fit the panel lower section (B) onto the left-hand side. 47 Fit the scuff plates at the left-hand rear door and front door (A). Saab 9-5...
- Page 21 Fit the scuff plate (D). · Fit the luggage compartment floor (C). · Lift in the cargo guard. · Fit the cover between the left-hand rear door and the backrest. Fold the rear seat backrest and seat cushions back into place. Saab 9-5...
- Page 22 · 1.8 - 1.3 m: 2 tones/second · 1.3 - 0.9 m: 3 tones/second · 0.9 - 0.3 m: from 5 to 12 tones/second in close stages · 0.3 m: continuous tone. Saab 9-5...
Need help?
Do you have a question about the 32 026 005 and is the answer not in the manual?
Questions and answers