Cobra G100 User Manual page 96

5.4 - Emergency Panel.
To be installed on the dashboard in a position that also ensures that the
button can be reached and the LED can be seen by the user, as in
addition to its deterrent function the panel (LED + button) is used during
programming operations and in the user recognition procedure.
INTRODUCTION.
This alarm system can self - learn a series of recurrent signals that take
place on the vehicle when the operations for locking and unlocking the
doors are executed the original radio control device. The signals that
are normally utilised are the engine comand, door deflector status and
direction indicator signals.
If connection to the direction indicators is foreseen for alarm activation
/ deactivation, please note that:
• the alarm may not activate / deactive when the vehicle's emergency
blinker is on.
6 - ARM / DISARM CONTROLS SELF - LEARNING PROCEDURE.
In order to memorise the arm / disarm commands via the car's original
remote control, the following conditions must be present:
1) G300 system disarmed.
2) Door and bonnet closed.
3) Ignition off (+ 15 absent).
Proceed as described:
A) Connect the GREY - BLACK lead to Ground (GND) for at least 2 s.
B) The LED will start to flash slowly
C) Press the Lock (close) button on the vehicle's original radiocontrol.
D) The LED flashes fast while awaiting the door opening signal.
122
06DE2245D OK.pmd 122
E) Press the Unlock (open) button on the vehicle's original
radiocontrol.
F) The confirmations of the happened self - learning process of the
signal is confirmed by an acoustic signal emitted by the buzzer.
7 - SHORT INSTRUCTIONS
7.1 - Arming by means of the vehicle's original radio controls:
• When the lock button on the original radiocontrol is pressed,
the doors lock and the system is armed.
• The buzzer emits two acoustic signals (if enabled).
• The LED lights up and stays on for 25 s, then flashes.
• The protection functions activate after 25 s.
7.2 - Arming with Driver Card.
It is also possible to connect the alarm system in the event of
an emergency by pressing the button on the Driver Card, without
locking the doors.
7.3 - Disarming using the Driver Card.
Introduction: the alarm is disconnected using the vehicle's original remote
control and by recognition of the Driver Card as follows:
7.3.1 - original radiocontrol recognition procedure.
• Press the original radiocontrol button to unlock the doors.
• The direction lights flash ("pre - disarm" phase).
• The protection functions are temporarily deactivated while
awaiting the Driver Card signal.
GB
USER AND FITTING INSTRUCTIONS
09/09/2008, 10.07
G300