HP N1528A Installation And User Manual page 75

Troubleshooting
Table 6-2. Fault Symptom Codes
Message
Unknown
The SCSI response
was not expected
The Flash response
was not expected
SCSI response not
matched to a known
command
Unexpected state after
NonVolConfig cmd
Unexpected state after
SCSI mode cmd
Unexpected state after
SCSI init cmd
Cartridge reject
recovery failed
Drive Fan stalled
Drive load did not
complete
Invalid drive was
installed
LTO unmask drive
failed
LTO mask drive failed
LTO unload drive (In
load retry) failed
Is Drive Unloaded
Failed
Orphan cartridge
recovery failed
Master pass-thru opto
failed
N1528A and N1529A ACL Tape Drive Installation and User's Guide—544594-003
FSC ERP
701E C, G
701F C, G
7020 C, G
7021 C, G
7022 C, G
7023 C, G
7024 C, G
8001 C, D, G
8002 C, D, G
8003 C, D, G
8004 F
8005 F
8006 F
8007 F
8008 F
9001 C, D, G
9003 C, D, G
6- 15
Fault Symptom Codes (FSCs)
Attempt to show detailed drive status of a
drive whose type is unknown.
The command response from the SCSI
task in a remote module was unexpected.
The command response from the Flash
task in a remote module was unexpected.
A command response was received from
a SCSI task, but the original command
opcode could not be determined.
After successfully completing a
NonVolCofigPut command, the current
state of the save operation was unknown
After successfully completing a
SCSIUpdateModeParameters command,
the current state of the save operation
was unknown.
After successfully completing a
SCSIInitcommand, the current state of the
save operation was unknown.
The drive failed to successfully load a
tape even after retries.
The fan in the drive hot-swap shoe is
either not installed or has stalled.
The drive failed to successfully load a
tape.
One or more installed drives are of a type
either unknown or not supported in the
current ACL personality.
The LTO drive unmask operation failed.
The LTO drive mask operation failed.
The LTO drive failed to unload a cartridge
during a load retry operation.
The LTO drive failed to return status when
being polled for unloaded state.
The master module could not successfully
return an orphan cartridge to a slot
location.
The master module opto sensor was not
detected during the power-up pass-thru
module inventory.