HP N1528A Installation And User Manual page 70

Troubleshooting
Table 6-2. Fault Symptom Codes
Message
Undefined Config
Orphan Cartridge not
flowed
Chassis S/N
Mismatch. Previous
S/N retained
Chassis S/N
Character count is not
correct
Chassis S/N did not
scan
Chassis S/N save
operation failed
Motor Firmware Error
Loader Received
Invalid Command
Motor Firmware Error
Missing Magazine
No Cartridges In ACL
Too Many Cartridges
Need 1 Drive
Minimum
Invalid Magazine Type
Magazine Type
Change Not Handled
Drive Type Not
Supported
Diag Fetch, Drive not
loaded
Diag Time-out waiting
for drive empty, ready
N1528A and N1529A ACL Tape Drive Installation and User's Guide—544594-003
FSC ERP
3020 C, G
3030 C, G
3031 G
3032 G
3033 G
3034 G
3040 C, G
3041 C, G
3042 C, G
3050 F
3051 F
3052 F
3054 F
3057 F
3058 F
3059 F
305b F
305d F
6- 10
Fault Symptom Codes (FSCs)
In loader, unexpected config, not a
Thunder or Lightning.
The loader could not successfully stow an
orphan cartridge to a bin.
The serial number scanned from the
barcode label does not match the value
stored in nonvolatile memory.
A valid serial number barcode label could
not be read.
A valid serial number barcode label could
not be read
The serial number scanned from the
barcode label could not be saved to
nonvolatile memory.
The loader task detected an unexpected
status and could not recover (internal
target error).
The loader task received an unexpected
command and could not recover (internal
target error).
The loader task detected an unexpected
status and could not recover (internal
target error).
In diag, no magazine installed for diag to
run.
No cartridge available for diag to run.
Unable to run cart or drive cycle, loader is
full with cartridges.
No available drive to run diag.
Unsupported Magazine type detected.
Unsupported magazine type detected.
Unsupported drive type detected.
Diag: No cartridge present for a fetch.
Fetch, time-out waiting for drive unload.